So if you are currently setup where you have multiple analog outs in use, routing things to different places, this will in turn affect what you hear (or don't hear) form the digital outs as well. NOTE: when using digital outs, it is important to realize that the digital signal is derived from whatever you have routed to your analog MIX outs. The Input parameter controls whether the K2 is the master (Input=Analog) or slave (Input=Digital).Īt this point if you generate audio on the K2 you should see its sample mode meters light up active, indicating the digital output is sending.Īssuming your receiving device is setup correctly (meaning as either master or slave, depending on your desired configuration) you now should have audio. If you need to slave to an external clock, connect the master signal to the digital input, switch Input to Digital, and set the value of the Cable parameter to coaxial or optical, based on the digital input. Set the Rate parameter as needed for cases where the K2 is the master.Set the Src parameter to Int for the K2's own analog mix output, or if you want to convert an external analog source to digital, set it to Ext.Set the value of Input to Analog to access the Source and Rate parameters.You may want to use AES/EBU in professional environments. Set the value of the Format parameter as needed.Set the value of the Input parameter to Digital to access the Format parameter.(In Program, Setup, Quick Access, or Master mode, press the Sample soft button.) Here's a step by step explanation of how to make the sampling option digital output work: This can be at a selected rate, either 48, 44.1, 32 or 29.6kHz, or can be slaved to an external clock. This digital output is actually the output of the sampler's Analog to Digital Converter, and can convert external analog signals, or the K2's analog mix output, into AES/EBU or SPDIF format. The sampling option provides a 16 bit stereo digital output, with both coaxial and optical connectors. You need to have the sampling option in your unit if you want to be able to have Digital Output. How can I enable the K2's sampling option digital output? The separate outs can also be used as insert points for external instruments, or to route a 2000 signal to an external effects processor and back into the instrument. Please read about this parameter in the manual for more info.
0 Comments
Leave a Reply. |